Action failed. Please refresh the page and retry.

SOLiC 200 Solar PV Immersion Controller/Diverter

£185.20 £172.00 (ex. VAT)
£206.40 (inc. VAT)

In Stock

SKU: MIS10063

The SOLiC 200 automatically converts energy generated by your existing PV panels into hot water by diverting excess solar power to the immersion heater before it’s exported to the national grid. Simple to use and maintenance free, the SOLiC 200 is self contained, easy to install and can save you hundreds of pounds over the course of a year.

The SOLiC 200 is guaranteed for 10 years and has been designed, constructed and fully tested in Britain to the highest CE standards. The unit can be installed quickly and easily by a qualified electrician without the need for plumbing alterations.

PLEASE NOTE: If a Solic 200 is installed alongside batteries, you CANNOT prioritise the charging of the battery system over heating your hot water. This means that until the water is up to temperature the Solic 200 will often take priority and may end up using some of the stored battery power to heat your water.

If you are looking to use an Immersion Diverter alongside a battery system, you would need to use either the iBoost, or the Eddi.

Features
Provides hot water from existing solar PV panels
Saves hundreds of pounds annually on your energy bills
Returns on investment in less than three years
Includes 10-year return-to-base replacement guarantee
Operates with a zero threshold export to the grid
Reduces your CO2 emissions
Requires no plumbing alterations
Works even on cloudy days
Installs quickly and easily
Complies with CE and British Standards
Engineered to last 25 years
Keeps indoor frost away when heating is off
Provides hot water in remote locations
Incorporates built-in overheating protection
Provides hot water instantly on return home from holiday
Works independently of solar installation
Uses compact and robust aluminium construction to prevent corrosion

Technical Specifications
Operation voltage: 230VAC mains – single phase 50Hz
Mains voltage: 205 – 260VAC
Power consumption: 0.025W (at 230VAC)
Active current: 0.005A
Transfer efficiency: 99.6% (at max power)
Maximum load current surge: 600A for 10ms
Maximum continuous load current: 40A
Mains frequency tolerance at 50Hz: nominally 2Hz
Operating temperature: 0 to 60C
Storage temperature: –20 to +75C
Operating and storage humidity: 10-90%, non-condensing
Lightning and ESD protection: to 1.8kV
Current tracking accuracy: better than 90%
Export activation threshold: 0W
Audible noise emissions: below 10dBA
RFI (EMC) emissions: below -52dBW
Maximum power dissipation at 3kW output: 12W
Internal fuse: 250V 500mA 20mm slow blow
Insulation resistance: above 10M Ohms
Case isolation protection: better than 2.0kV
Case dimensions: 161 x 105 x 57mm
Total mass as packaged: 625g

5.00 out of 5

1 review for SOLiC 200 Solar PV Immersion Controller/Diverter

  1. 5 out of 5

    Rating by Christian on February 8, 2022:

    Its amazing! Meter wheel stops dead when turned on during export. In my set up it serves as a safety net to catch the bits the battery charger misses when batteries are nearly full or not enough feed in for the charger to start up.

Add Review

Add a review

*