Renusol Console+ Tub (with fixings) for Ground or Flat Roof Mount

The Renusol ConSole+ Tub is a ballasted solution for installing Solar Panels in Landscape Orientation on flat roofs or the ground.

The ConSole+ provides an angle of 15° and can be fitted to flat roofs with a pitch of up to 5°. The majority of commercially available Solar Panels are compatible and will fit on the ConSole+.

The ConSole+ is weighed down with ballast. Any material can be used: gravel, paving slabs, bricks, rocks etc. The amount of ballast depends on the height and location of the building.

Mounting components are included for the Solar Panels. The Solar Panels attach to the mounts using the mounting holes on the back of the module. Please check the measurements below against your panel specification:

– Max module length: 1550mm – 2150 mm

– Holes gap – width: 895mm – 1014 mm (you can increase this up to a maximum panel hole gap (width) of 1185mm, by using the Renusol Console Elongation Rail Set)

You can also use 2 x Renusol Console Elongation Rail Sets  to allow for a maximum panel hole gap (width) of 1155mm

– Holes gap – length: 690mm – 1180 mm

Note: The hole gap should be given on the panel datasheet in a form similar to the picture below. 

Renusol Console+ Tub (with all fixings) includes:
1 x ConSole+ Tub
2 x ConSole U-Profile 1035 mm
4 x Hexagonal Screw (DIN933-M6x20 A2-70)
4 x Washer (DIN9021-6,4-A2)
4 x Self-locking Hexagonal Nut (DIN985-M6-A2)
4 x ConSole Clip
4 x Hexagonal Screw (DIN7504-ST5,5×25-A2-SW8)

(Solar Panels/Ballast not included)

Downloads